Coherent FieldMaxII-TOP Manuel d'utilisateur télécharger pdf (Page 47)

Operation

Stat

Pressing the Stat button will:

• Enter Statistics mode—if Statistics mode is not

active and the button is pressed for less than two

seconds.

• Exit Statistics mode.

• Enter Edit mode and select the statistics parameters

to be edited (Batch Size and Restart mode) after

edit cycle initiation (if Setup/Local is pressed

beforehand). Batch size is 2 to 99,999 pulses (ther-

mopile sensors in Joules mode, or pyroelectric

sensors), or 1 to 99,999 seconds (thermopile

sensors in Watts mode, or optical sensors).

• View the statistics parameters if the button is

pressed for two seconds or more.

Wave

You can configure FieldMaxII-TOP to automati-

cally account for any difference between the laser

wavelength and the calibration wavelength. In the

case of optical sensors, this compensation is necessary

because the sensor contains calibration data from a

number of different wavelengths. Thermopile and

optical sensors include wavelength compensation infor-

mation that is used in this mode.

After pressing Setup/Local, the Wave button is used to

enter Edit mode and set the wavelength. If an edit cycle

has not been initiated, pressing the Wave button will

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 117 118

Pas de commentaire

Coherent FieldMaxII-TOP Manuel d'utilisateur Page 47