Coherent FieldMaxII-TOP Manuel d'utilisateur télécharger pdf (Page 81)

Host Interface

propget HoldMode([out, retval] VARIANT_BOOL* );

The read only property indicating hold mode state. This

parameter has effect only with a TO meter.

propget LastData([out, retval] double* );

The read only property indicating the last measurement

value. This property is read in response to a “Measure-

mentData” event.

propget LastFault([out, retval] short* );

The read only property indicating the fault code of the

last fault event. This property is read in response to a

“Fault” event. The last fault code may be cleared by

calling the DismissFault() method.

propget LastPeriod([out, retval] double* );

The read only property indicating the last period value.

This property is meaningful only when a pyroelectric

probe is attached. Frequency in Hz is calculated as

125000/LastPeriod.

propget MaxRange([out, retval] double* );

The read only property indicating the maximum full

scale range that the meter will accommodate. This prop-

erty automatically varies as different probes are attached.

propget MaxWavelength([out, retval] long* );

The read only property indicating the maximum wave-

length that the meter will accommodate. This property

automatically varies as different probes are attached.

propget MeasurementMode([out, retval] short* );

The read only property indicating the measurement

mode (Watts or Joules).

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 99 100

Pas de commentaire

Coherent FieldMaxII-TOP Manuel d'utilisateur Page 81